May 29, 2010 ( PowerHomeBiz.com )
-
When it comes to geothermal energy, Australia may not hold the top spot in
the utilization of this renewable energy, but the potential is certainly
there. As it has with other renewables, Australia has turned its attention
to geothermal energy as a means to reach certain energy generation goals by
the end of the year. These goals somewhat mirror the guidelines set by the
Kyoto Protocol.
(article continued below ...)
Why isn’t geothermal energy as prolific in Australia as in other parts of
the world? One reason is that the geothermal energy found in much of
Australia is not what is considered “wet.” Wet geothermal is found in areas
that contain volcanic activity in which super heated water lies near or on
the surface of the Earth. The steam created by this water rotates turbines
that generate electricity. Because Australia is not volcanically active,
binary power plants are used. As you would expect from something that is
binary, it is a two-step process. Unlike wet systems in which the water is
already hot enough to produce steam that rotates a power turban, water is
injected into hot granite to create steam in a binary system. In Australia,
this granite lies 3-5 km below the surface. A heat exchanger transfers the
energy from the heated fluid to what is known as a working fluid (such as
ammonia). The working fluid vaporizes in the exchanger and is then expanded
in a turbine, generating electricity. As you might guess, the multiple steps
involved in a binary geothermal system are costlier than in a wet system.
Australian authorities have stated, however, that geothermal energy will be
cost competitive with that of carbon-based energies.
Geodynamics, a company based in Australia, may have found an area in
South Australia that would lessen the cost of geothermal energy generation.
They claim that the Cooper Basin contains granite measured to be the hottest
rocks ever recorded on the planet. And because the overlaying rocks that act
as an insulation blanket have been found to be fractured, pressurized water
inside them could flow to the surface and the heat would then be extracted
to power turbines. The water would then return to the incredibly hot rocks
below, allowing the process to start again. Because this water is naturally
occurring, the need for outside water sources is eliminated, lowering the
cost of geothermal energy production.
As further exploration of geothermal energy in Australia is conducted,
more hot spots are sure to be found and this renewable energy will become
method of energy generation for years to come.
At new-energy-portal.com you can find a wide array of Geothermal Heating
Manufacturers and Geothermal Heating Suppliers in Australia. This is the
perfect source to make the most of them!